Mining Seal XSW51

Function:
Wipers are designed to keep dust, dirt, sand and others off the rod and the sealing and guiding elements, avoiding abrasive damage caused by external contamination.

Features:
  • The profile is designed with interference on the OD which provides a good static fit, preventing the entry of humidity and other contamination via the outside diameter.
  • Additional sealing on the housing face.
  • Sharp wiping lip to ensure any dirt is wiped off properly.
  • Secundary lip for stabilizing and reducing the residual oil film.
  • Pressure from the trailing side has to be avoided.

Application

  • Reciprocation rods in hydraulic cylinders, plungers, rolling mills.
  • Max. pressure 0 bar, max. speed 2 m/s.

Seal housing recommandation

Tolerances
L < 10 mm
+ 0.2 mm 
L ≥ 10 mm
+ 0.3 mm 
∅ NA
H11 
∅ NI
f8 
 
Surface roughnessRtmax [µ] Ra [µ] 
Bottom of groove
≤ 6.3≤ 1,6
Face of groove
≤ 15≤ 3
 
Sliding surfaceRtmax [µ] Ra [µ] 
PU, elastormeres
≤ 2.5≤ 0.1 - 0.5
PTFE
≤ 2≤ 0.05 - 0.3

Installation

Snap-in installation.

When the cylinder can not be dismantled, the wiper can also be installed in cut version. In this case the diameter should be increased by 2-3%.