Rod Seal XSRS17D

Function:
Rod seals are designed to seal the pressurized hydraulic fluid against the atmosphere, preventing leakage and pollution of the environment.

Features:

  • Asymmetrical, single acting rod seal, designed with interference on the OD which provides a good static fit in the groove.
  • Special design for small cross sections where lips would be too thin.
  • Secundary lip for stabilising at large seal heights and reducing the residual oil film.
  • Excellent static and dynamic sealing performance.
  • Excellent performance over all pressure ranges.
  • Used for short pulsating strokes.
  • No reverse leakage when changing direction.
  • Recommended for positioning or holding under pressure.
  • Particularly suitable for high viscosity media.

  • Reciprocating pistons/rods in hydraulic cylinders, push rods, fittings etc.
  • Switching or clamping functions.
  • Replacement for rubber fabric seals.
  • Max. pressure 400 bar, max. speed 0.5 m/s for all HPU types.
  • Max. pressure 400 bar, max. speed 0.7 m/s for HPU94 GM.
  • Max. pressure 160 bar, max. speed 0.5 m/s for all elastomer types.

Tolerances [mm]   
L < 10 mm
+ 0,2  
L ≥ 10 mm
+ 0,3  
∅ NA
H10  
∅ NI
f8  
 
Surface roughness Rtmax [ µ]  Ra [ µ] 
Bottom of groove
≤ 6,3 ≤ 1,6
Face of groove
≤ 15 ≤ 3
 
Sliding surface Rtmax [ µ]  Ra [ µ] 
PU, elastormeres
≤ 2,5 ≤ 0,1 - 0,5
PTFE
≤ 2 ≤ 0,05 - 0,3

Snap-in installation