Rod Seal XSRS02

Function:
Rod seals are designed to seal the pressurized hydraulic fluid against the atmosphere, preventing leakage and pollution of the environment.

Features:

  • Asymmetrical, single acting rod seal, designed with interference on the OD which provides a good static fit in the groove.
  • Dynamic sealing lip shorter than static lip to avoid drag pressure.
  • Excellent static and dynamic sealing performance.
  • Useable for long stroke lengths.
  • Negligible tendency to “stick-slip” effect above a speed of 0.15 m/s.
  • For lower speeds the dynamic lip should be redesigned (shorter, stiffer).
  • Activated back-up rings prevent and reduce gap extrusion.

  • Reciprocation rods in hydraulic cylinders, plungers.
  • Universal rod seal for larger extrusion gaps and higher load impacts.
  • Max. pressure 700 bar, max. speed 0.5 m/s, depending on material selection.

Tolerances [mm]   
L < 10 mm
+ 0,2  
L ≥ 10 mm
+ 0,3  
∅ NA
H10  
∅ NI
f8  
 
Surface roughness Rtmax [ µ]  Ra [ µ] 
Bottom of groove
≤ 6,3 ≤ 1,6
Face of groove
≤ 15 ≤ 3
 
Sliding surface Rtmax [ µ]  Ra [ µ] 
PU, elastormeres
≤ 2,5 ≤ 0,1 - 0,5
PTFE
≤ 2 ≤ 0,05 - 0,3

Snap-in installation.